Azteeg X1 - 'RAMPS On Steroids'

Azteeg X1 - 'RAMPS On Steroids'

Azteeg X1 - 'RAMPS On Steroids'

More details


$70.00

Availability: OUT OF STOCK

Link to the RepRap Wiki Entry for the Board
 
The Azteeg X1 is SINGLE EXTRUDER compatible, open source controller designed to be used in RepRap 3D Printers and similar cartesian based machines including CNCs. It has all the features needed to run all current and future single extruder designs. Will work with Prusa Mendel, Mendel Max, Ordbot, Printrbot and most 3D printers
 
 
The Azteeg X1 is based on Sanguino/Sanguinololu and is compatible with most Arduino based firmware(Sprinter, Marlin, Repetier, plus others.). It is pin to pin compatible with the Sanguinololu with the addition of a FAN PIN.
 
Compatible with Pololu and SureStepr stepper motor drivers with the ability to use an external power source for the motors with higher voltages.
 
The Azteeg X1 3DP is your low cost, compact and expandable 3DP printer controller. Fully Assembled with screw terminals for easy and fast connection.
 
  • Atmel ATMEGA1284P with FT232RL FTDI USB chip. (ATMEGA 644P on v1.0) 
  • RoHS Compliant
  • Compatible with Sprinter, Marlin, Repetier and More
  • Mosfet control for 1 extruder and 1 hotbed
  • Extra PWM control for small fan or LEDs
  • 3 end stops and 2 thermistor inputs
  • 12-30v input high efficiency switching Power supply @ 500ma max
  • Dedicated uSD card female header [SDRAMPS compatible]
  • Low RDSon Mosfets for less heat buildup
  • Input power selector for micro controller [USB or internal regulator]
  • Secondary power input for stepper motors
  • Optional pads for TVS spike suppression diodes for the Mosfets
  • Mosfet Heatsinks included
  • i2C, Tx1 serial, +5, GND, SPI and ADC pins on the expansion ports
  • Fast acting blade fuse
  • Both right angle and vertical connector sets included
  • Lots of LEDs, Rx/TX serial, PWR, hot end and hot bed

Cart  

No products

Shipping $0.00
Total $0.00

Cart Check out